Stone Design Forums

Tried to make a A4 > A1 poster with PStill and it just came out as the same size as original (A4).

I did the Cmd-T tiling option and set it up -- all looked fine -- but the output didn't work. Tried several times with slightly different settings.

Any suggestions? (I used the free utility Tiler in the finish because I had to get the job out)

Ian Greig

So, first you must pass any PDF through PSTill, and then tile that. It must be only one page, send it to me so I can see what's going on...

Aha! Was trying to tile the original system pdf. Now I know.

Have been having some difficulties making pdfs via Print menu and PStill -- getting offsets. So I generally make them via the MacOS.

Presumably if I was successful in making the pdf in PStikll in the first place, then it would tile OK?

Thanks for the quick reply -- this is such a good community

IanG

Exactly - it must have gone through PStill at least once - so if that's how it was created, that extra step is not needed.

Got a perfect tile after following the exact procedure – thanks Andrew